PRODUCT
- mailbox:[email protected]
Industry information
Sprocket processing flow
The sprocket processing process is commonly used in biotechnology, thermal insulation medical equipment, finished food products, appearance supplies, kerosene and other old medical equipment.
Sprocket machining process component configuration
. The tooth profile of the sprocket machining process. The tooth profile of the sprocket machining process can only be protected to ensure the protection of the energy-saving chain. The turbulence of the chain can easily enter and enter the machine tool, which can reduce the guard and contact stress of the chain link during the machine tool.
High-quality sprocket machining process end tooth profile.It is composed of three arcs aa, ab, cd and some parts to develop hardness and strength bc, simplifying the tooth profile of three arcs-developing hardness and strength.Tooth profile is finished with standard tool, draw the end face tooth profile on the grid on the sprocket processing flow chart, you only need to label "tooth profile to be made according to 3RGB1244-85 instructions" on the drawing, but the sprocket processing flow should be drawn For the tooth profile of the shaft surface, refer to the time to determine the configuration manual.
. Sprocket machining process components
The processing flow of small elliptical diameter sprocket usually causes serious type, and the processing flow of ordinary elliptical diameter sprocket usually causes the spoke type. In order to facilitate handling, installation and weight reduction, damage on the spoke plate, processing flow of large elliptical diameter sprocket It can cause a combined combination, and now the ring gear and the wheel core can be made with no color! It is inconvenient to wait for the color.
. Sprocket process color
The color of the sprocket processing flow should be protected to ensure protection to ensure that the gear teeth have a little development, hardness, strength and stability. Therefore, the tooth surface of the sprocket processing flow is generally targeted to be hot, so that it can be combined to a certain extent.
Maintenance and conversion of sprocket machining process
, The tightness of the sprocket processing flow should be used skillfully. If it is too tight, it will be supplemented and consumed. The bearing is simple and hard-toothed cylindrical gear reducer; the processing flow of the sprocket is too loose and simply exits and is too much.The tightness of the sprocket processing flow is as follows: from the middle of the sprocket processing flow to or press down to produce 2%-3% of the main distance between the two sprocket processing flow.
, The shaft of the sprocket processing process equipment should be constantly swinging and complete.In the same spreading influence, the end surface of a certain sprocket processing flow should be in the same position. When the sprocket processing flow is mainly under 0.5 meters, the door panel may be disadvantageous; the sprocket processing flow is mainly at the first few of .5 meters At times, the door panels can be shortcomings.However, there must not be an encounter between the sprocket processing process and the tooth lift. It is found that if the two wheels offset too much, it is easy to see more and accelerate the hardened cylindrical gear reducer.When wiring the sprocket processing flow, the only way to do a good job of guarding and analyzing the offset sprocket processing flow.
Previous: Zhengtai sprocket
Next: Ningbo sprocket gear