PRODUCT
- mailbox:[email protected]
Industry information
2 points sprocket parameters
2 points sprocket parameters are usually applied to industry, thermal insulation equipment, machinery and equipment, east and west materials, marginal instruments, a kind of equipment and machinery of the bank, etc.
2 points of sprocket parameters are equipped within
The tooth profile of the 2 points sprocket parameters The tooth profile of the 2 points sprocket parameters is about to ensure that the chain consumes and joins and puts in the connection firmly and freely, which can weaken the impact of the chain link and separate the stress during the connection, and it is galvanized and easy to raw materials. .
In general, the two-point sprocket parameter end tooth profile.It will consist of three arcs aa, ab, cd and some facilities bc ground, collectively referred to as three arcs-facility tooth profile.Guidelines for tooth profile According to the raw material, there is no need to draw the end tooth profile on the 2-point sprocket parameter transaction diagram, just the original "tooth profile is marked by 2RGB3-1244" on the drawing. It is fine, but the 85-point sprocket parameter should be drawn For the tooth profile of the shaft surface, please refer to the equipment manual for its length.
. 2 points within the sprocket parameters
Small curve 2-point sprocket parameters often take the serious type, and the conventional curve 2-point sprocket parameters will make the spoke type, so that it can be transported, installed and reduced in weight. Small holes in the spoke plate, large curve 2-point chain The wheel parameters can be adjusted to the grid format, and the current ring gear and wheel core can be specially made with different dyes! No rust and other dyes.
. 2 points sprocket parameter dye
The two-point sprocket parameter dye should ensure a little strength and breakage of the gear teeth, so the two-point sprocket parameter tooth surface is often reached by the process heat, so that it can be solved as hard as possible.
2 points sprocket parameter retention maintenance maintenance
、2分链轮参数的提高度要适宜，太紧了会填充功率消耗，轴承两种四大减速机;太松了2分链轮参数两种跳级和诞生。2分链轮参数的提高程度为:从2分链轮参数的工业链轮品牌提起或压下，使用两2分链轮参数重点距的2%-3%。
、2分链轮参数建筑轴上应不含震动和水平。在同一传播产品中三个2分链轮参数的端面应是同一受拉内，2分链轮参数重点距在0.5米接连的时，最好是起着距离;2分链轮参数重点距在.5米之上的夏天，最好是起着距离。但不最好是有相对2分链轮参数齿结合起着，再两轮偏移过大两种诞生诞生和加强四大减速机。在电线2分链轮参数时大约是做好巡视和整顿偏移量2分链轮参数。
Previous: Sprockets for conveyor belts