PRODUCT
- mailbox:[email protected]
Industry information
Sprockets for conveyor belts
Sprockets for conveyor belts are routinely used for light industry, isolation and anticorrosion, dining is not, instrument cold storage, sprocket and other door anticorrosion spread, etc.
Conveyor belt with sprocket inside building
. The tooth profile of the sprocket for the conveyor belt. The tooth profile of the sprocket for the conveyor belt is probably the protection chain.
The tooth profile of the sprocket is commonly used for conveyor belts.It must be composed of three arcs aa, ab, cd and four sectors bc, which is a practical three-arc-sector tooth shape.The tooth profile system will not be updated. It is not necessary to draw the end tooth profile on the various diagrams of the conveyor belt sprocket. You only need to bookmark the "tooth profile according to the 3RGB1244-85 standard, also known as" on the diagram, but you should draw the conveyor belt chain. For the tooth profile of the axle surface of the wheel, please refer to the Wugan Construction Manual for its style.
. Inside the sprocket for the conveyor belt
Sprockets for small anti-corrosion conveyor belts are often used and generally become critical. Sprockets for general anti-corrosion conveyor belts are mostly spokes. For easy handling, chucking and decrement, cables on the spokes and sprockets for large anti-corrosion conveyor belts can become Alkali-resistant, the process gear ring and the wheel core are used in combination with different materials, aka!, not the machine and other materials.
. Sprocket material for conveyor belt
The material of the sprocket for the conveyor belt should protect the gear teeth from being rich and damaged. Therefore, the tooth surface of the sprocket for the conveyor belt is often used to remove the heat through the general process to make it reach the window.
Maintenance of sprocket for conveyor belt
The tightness of the sprocket for the conveyor belt should be used skillfully. If it is too tight, the cost of economy and precision will be injected. The bearing is called the material involute cylindrical gear reducer; the sprocket for the conveyor belt is called the material wear and but not.The degree of elasticity of the sprocket for the conveyor belt is as follows: the second part of the sprocket for the conveyor belt is worn or pressed down, about 2%-3% of the key distance between the sprocket for the conveyor belt.
, Conveyor belt with sprocket mounted on the shaft, the fiber web should be taken off and be completely vertical.In the unified circulation equipment, the end faces of the sprocket for both conveyor belts should be located within the unified upper surface. When the key distance of the sprocket for the conveyor belt is 0.5 meters later, it is better to deviate the hinge; the key distance of the sprocket for the conveyor belt is more than 5 meters. It's better to deviate from the hinge in the autumn of the point.However, it is not best to use sprocket teeth for resistance conveyor belts. It is assumed to be so. Therefore, if the two wheels are offset, the material is exposed but does not accelerate the involute cylindrical gear reducer.When using sprocket for wire conveyor belt, it is probably important to look at and adjust the amount of offset conveyor sprocket.
Previous: Double speed sprocket drawings