Transmission sprocket processing

Time: 2020-3-19 16:13:50 Source: Hebei Ever-Power Sprocket Factory

Transmission sprocket processing is widely used in biotechnology, dust-free facilities, food production, demeanor food, chain teeth and other door attendants.
Transmission sprocket processing internal development architectural design
. The tooth profile of the transmission sprocket processing. The tooth profile of the transmission sprocket must take care of the chain, cost-effective, energy-saving, stable and light. It can increase the impact and isolate the stress of the chain link when it rises and decreases.
The drive sprocket is often used to process the end tooth profile.It is composed of three arcs aa, ab, cd and some straight bc parts, which are collectively called three arcs-straight tooth profile.The tooth profile is overlaid with the target rule. It will not be easy to face the tooth profile on the diagram of the transmission sprocket processing. You need to bookmark the "tooth profile according to 3RGB1244-85 exhaust gas" on the diagram, but it should be easy to drive the sprocket. For the machined shaft tooth profile, refer to its style to confirm the development of the architectural design manual.
. Transmission sprocket processing internal
Small effect transmission sprocket processing is often used to make the general serious type, and the flat effect transmission sprocket processing is mostly made into the spoke type, in order to facilitate the handling, installation and reduction, outside the spokes, the large effect transmission sprocket processing can be made In an overlaid style, at this time the ring gear and the wheel core are suitable but no dye exhaust gas!, no tax and other dyes.
. Transmission sprocket processing dyes
Transmission sprocket processing dyes should protect the gear teeth to have sufficient needs and wear resistance, so the transmission sprocket processing tooth surface is often used to clean it out with sound insulation and heat, so that it can be removed and combined.
Transmission sprocket processing and maintenance service
, Transmission sprocket processing needs to be used, too tight will be compared, the purpose of flat round tooth sprocket should be applied, too tight will determine how to make money quickly, bearing material bearing; too loose transmission sprocket processing material jump And eagerly.The commercial tax for the processing of the transmission sprocket is: 2%-3% of the main processing distance of the two transmission sprocket processing from the sandwich technology or reduction of the transmission sprocket processing.
, The transmission sprocket processing and mounting shaft should swing and level the fiber mesh.In the same color equipment, the end surface of a transmission sprocket processing should be within the same temperament. When the transmission sprocket processing distance is shared below 0.5 meters, the deviation will be millimeters; the transmission sprocket processing distance is mainly 5 meters above. The deviation is millimeters.But there is no such thing as the extreme force of the processing teeth of the transmission sprocket. It is precisely because of this that the two wheels are offset and the material shows the extreme force and strengthens the bearing.When processing wiring transmission sprocket, attention must be paid to checking and rectifying the processing of offset transmission sprocket.

Previous: Hatch sprockets

Next: Hebei Yongnian Sprocket