Do you know the cleaning process of the sprocket?

Time: 2016-5-27 15:19:17 Source: Hebei Ever-Power Sprocket Factory

新SprocketIf it is too long or stretched after use, it is difficult to adjust. You can remove the chain link depending on the situation, but it must be an even number.The chain link should pass through the back of the sprocket, the lock piece should be inserted outside, and the opening of the lock piece should face the opposite direction of rotation.

The sprocket should be filled with lubricating oil in time during work.Lubricating oil must enter the matching gap between the roller and the inner sleeve to improve working conditions and reduce wear.
The old sprocket cannot be mixed with some new sprocket, otherwise it is easy to produce impact in the transmission and break the sprocket.
When the machine is stored for a long time, the sprocket should be removed and cleaned with kerosene or diesel oil, and then coated with oil or butter and stored in a dry place.

The sprocket should not swing and skew when installed on the shaft.In the same transmission assembly, the end faces of the two sprockets should be in the same plane. When the center distance of the sprocket is less than 0.5 meters, the deviation can be 1 mm; when the center distance of the sprocket is more than 0.5 meters, the deviation can be 2 mm.However, there must be no friction on the side surfaces of the sprocket teeth. If the two wheels offset too much, it will easily cause chain disconnection and accelerated wear.When replacing the sprocket, you must pay attention to check and adjust the offset.

Previous: How to use the worn sprocket reasonably

Next: Explanation of the close relationship between sprocket quality and material