Sprocket chain coordination

Time: 2021-3-31 13:59:52 Source: Hebei Ever-Power Sprocket Factory

Sprockets and chains are used in daily common use for steelmaking, nursery products, meal cotton making, appearance props, quantity and other professional product blocks, etc.
Sprocket and chain matching structure construction
. The toothed sprocket chain matched with the sprocket chain is basically a cost-effective, stable entry and exit of the chain. Carefully lower the impact of the chain link and touch the stress during the fitting, and the plug should be easy to make cotton.
The commonly used sprocket chain matches the tooth profile of the end face.It is flattened by three arcs aa, ab, cd and some sectors bc, suitable for three arc-sector tooth shapes.The tooth profile is made of cotton with a marked tool. The sprocket and chain do not need to be cheap and affordable. You need to mark the "tooth profile according to 3RGB1244-85 to indicate exhaust gas" on the map. It will work, but it should be cheap and affordable. Please refer to the construction manual for the style of the tooth profile of the shaft surface matched with the chain.
. Sprocket chain matching structure
In general, the small-impact sprocket chain coordination leads to the key type, and the flat-level influence sprocket chain coordination leads to the spoke type. In order to be able to carry, install and reduce the weight, the impact on the spoke plate, the large impact sprocket chain coordination can lead to The combined type restricts the use of different raw materials and exhaust gas for the ring gear and the wheel core, not construction and other raw materials.
. Sprocket and chain with raw materials
The sprocket and chain with raw materials should have some regularity and damage to the teeth. Therefore, the sprocket and chain with the tooth surface are generally sound and heat insulated to remove a certain degree of hardness.
Sprocket chain replacement and maintenance
, The solution of the sprocket and chain coordination should be practical, too tight will increase and pay, the bearing is inherently lift reducer; the sprocket and chain that are too loose are inherently high jump and fall.The resolution of sprocket chain matching is: from the middle of the sprocket chain matching, it is easy to understand or press down, and the production of two sprocket chain matching core distances is 2%-3%.
, Sprockets, chains and industrial shafts should be resistant to alkali wiring and time.In the same block assembly, the mating end faces of a sprocket and chain should be in the same platform. When the sprocket and chain match the core distance of 0.5 meters and immediately share, it is probably biased toward the hinge; the sprocket and chain match the core distance of .5 meters In the autumn of the previous year, it was probably biased towards the hinge.However, it is unlikely that there will be a problem with the sprocket chain matching tooth lifting phenomenon, if the two-wheel offset is mainly inherently caused by the fall and speed up the elevator reducer.When repairing the sprocket and chain coordination, the basic attention is paid to the inspection and the statistical offset sprocket chain coordination.

Previous: Sprocket gear

Next: Sprocket design standards for sprocket manufacturers in Yunnan