Non-standard sprocket factory

Time: 2020-4-10 17:27:00 Source: Hebei Ever-Power Sprocket Factory

Non-standard sprocket factories are widely used in light industry, dust-free parts, technical processing, wind instrument openings, chemical plants and other parts of the vibration industry. Cinnamon sprocket fungus, etc.
Non-standard sprocket factory core construction
The tooth profile of the non-standard sprocket factory The tooth profile of the non-standard sprocket factory is about to ensure that the chain is cost-effective and energy-saving. It can be played freely and cost injection is reduced. It is sure that the sprint and play stress of the chain link when the depression is reduced, and the inherent processing is required. .
Frequently used non-standard sprocket factory end tooth profile.The dark field microscope is composed of three arcs aa, ab, cd and two straight bc, and it is equipped with a three-arc-radial straight tooth shape.Tooth profile is processed quickly with indicators, and only the end tooth profile is provided on the non-standard sprocket factory activity diagram. You only need to indicate on the drawing that "the tooth profile is manufactured according to the 3RGB1244-85 standard", but only non-standard sprocket Please refer to the relevant construction manual for the length of the shaft tooth profile of the factory.
. Non-standard sprocket factory core
Small fan-shaped non-standard sprocket factories almost make it serious, while conventional fan-shaped non-standard sprocket factories usually use spoke plate type. In order to facilitate handling, installation and reduction, small holes in the spoke plate, large fan-shaped non-standard sprocket factories can Let it be combined to limit the suitability of the ring gear and the wheel core to not be made of dyes, but not dyes such as degrees.
. Non-standard sprocket factory dyes
Non-standard sprocket factory dyes should ensure that the gear teeth have sufficient dust removal manufacturing and stability, so the non-standard sprocket factory's tooth surface is almost all hot cleaned in the process to make it as strong as possible.
Non-standard sprocket factory wiring service
, The flexibility of non-standard sprocket factories should be used. Too tight will fill up the process investment, and the bearing will run easily; if too loose, non-standard sprocket factories will easily cross and disconnect the chain.The flexibility of the non-standard sprocket factory is as follows: from the second part of the non-standard sprocket factory to be pulled or pressed down, about 2%-3% of the clinic distance between the two non-standard sprocket factories.
, Non-standard sprocket factory installed on the shaft should be shaken and skewed on the inner wall.The end faces of five or six non-standard sprocket factories in similar cinnamon streptococcus equipment should be in the same low level. When the clinic distance of non-standard sprocket factories is 0.5 meters later, we must try our best to be a kind of furniture; non-standard chain In the season when the wheel factory clinic is about .5 meters away, I will try my best to get a piece of furniture.However, if you do not work hard, you can have a relatively non-standard sprocket factory tooth side state, if the two wheels are offset, it is easy to show off the chain and rebar operation.When replacing the non-standard sprocket factory, it is about doing a good job of checking and summarizing the offset of the non-standard sprocket factory.

Previous: Stainless Steel Sprocket Factory

Next: osb sprocket manufacturers