PRODUCT
- mailbox:[email protected]
Press Room
Stainless Steel Sprocket Factory
The stainless steel sprocket factory is used in the chemical industry, grade equipment, food, instrument, and other industries.
Stainless steel sprocket factory tree building inside
The tooth profile of the stainless steel sprocket factory can only maintain the cost-effectiveness of the chain. It can participate in and participate in the meshing rigorously, which can hold and isolate the stress of the chain link during the low meshing, and the bite must be inherently not.
The end tooth profile of the general stainless steel sprocket factory is often used.It is flattened by three arcs aa, ab, cd and some direct bc, referred to as three arcs-direct tooth shape.The tooth profile is used to indicate that the process will not be carried out. In the accident diagram of the stainless steel sprocket factory, there is no need for the sprocket angle end tooth profile. You only need to add the theme "tooth profile according to the 3RGB1244-85 guideline standard granite" on the map. , But should be the sprocket's wrap angle stainless steel sprocket factory's shaft tooth profile, and its time refers to the construction manual.
. Inside the stainless steel sprocket factory tree
The quality of small direct stainless steel sprocket factories can be made into dangerous type. Generally, direct stainless steel sprocket factories can make it into a spoke type. For quick handling, loading and weight reduction, damage on the spoke plate is possible. Dazhi stainless steel sprocket factory can make it possible to make it into a mortar connection type. At this time, the ring gear and the wheel core are not plate granite, non-rust and other plates.
. Stainless Steel Sprocket Factory Plate
The stainless steel sprocket factory plate should maintain a small amount of alloy and wearability of the gear teeth, so the quality of the tooth surface of the stainless steel sprocket factory is based on the principle of thermal cleaning to remove the careful density.
Stainless steel sprocket factory wiring line
, The tightness of the stainless steel sprocket factory should be suitable, too tight will increase the power of asbestos, bearing high-efficiency electric drum reducer; too loose stainless steel sprocket factory efficient beating and performance.The tightness of the stainless steel sprocket factory is: from the sandwich bearing or the pressure of the stainless steel sprocket factory, reduce the original intention of the two stainless steel sprocket factories by 2%-3%.
, There should be no vibration and complete verticality on the life axis of the stainless steel sprocket factory.In the influence of the wrap angle of the same sprocket, the end surface of a stainless steel sprocket factory should be in the same platform. When the original intention of the stainless steel sprocket factory is less than 0.5 meters, it is also called to be careful; the original intention of the stainless steel sprocket factory is. In the season above 5 meters, beware of shortcomings is also called.However, accidental use of factory teeth containing stainless steel sprocket, so the two-wheel offset is too large to efficiently form performance and strengthen the electric drum reducer.When safeguarding the stainless steel sprocket factory, the only way to do excellent observation and analysis of the offset stainless steel sprocket factory.
Previous: Shearer sprocket