a Sprocket standard

Time: 2020-4-15 17:24:27 Source: Hebei Ever-Power Sprocket Factory

a The sprocket standard is widely used in non-magnetic, equipment, food production, style equipment, molding and other equipment, heavy industry, etc.
a Sprocket standard facility structure
a. The standard tooth profile of the sprocket. The standard tooth profile of the sprocket is also more than less than, greater than less than less than, and must be protected. In case of stress, it is necessary to produce superiority.
Almost the standard end tooth profile of a sprocket.It must be composed of three arcs aa, ab, cd and a sector bc part, referred to as three arcs-sector tooth shape.The tooth profile is used to indicate the construction and production. Create a shield on the standard working drawing of a sprocket to ensure the protection of the end face tooth profile. You need to label the "tooth profile according to the 3RGB1244-85 system" on the drawing. For the standard shaft tooth profile of the sprocket, refer to the relationship structure manual for its life.
.a Sprocket standard facilities
Small medical equipment a sprocket standard generally produces a monolithic type, and medium medical equipment a sprocket standard mostly produces a trigger-spoke type. In order to facilitate handling, installation and reduction, holes are opened on the spokes. The large medical equipment a sprocket standard can be The trigger mortar connection type is generated. At this time, the ring gear and the wheel core are appropriate but not in the past! The machine does not wait for the past.
. A sprocket standard in the past
In the past, the standard of a sprocket should protect the gear teeth with a little bit of hardness, strength and wear resistance. Therefore, the standard tooth surface of a sprocket is generally thermally arranged to make it handle the best density.
a The sprocket standard retains the maintenance guarantee
The improvement of a sprocket standard should be used. Too tight will increase the cleaning and adding. The bearing has a simple planetary gear reducer; if it is too loose, a sprocket standard has a simple 35 sprocket and it will definitely be possible. The increase in commercial tax for a sprocket standard is: pull or press down from the middle of a sprocket standard, and reduce 2%-3% of the critical distance of the two a sprocket standard.
, A sprocket standard equipment shaft should have a surface and tilt.In the same heavy industrial equipment, the standard end faces of a sprocket should be in the same three-dimensional address. When the standard key distance of a sprocket is below 0.5 meters, try to use a new type of centimeter; the standard key distance of a sprocket is above .5 meters In time, I will try my best to be able to create new centimeters.However, if you do not work hard, you will be able to successfully issue a sprocket with standard teeth, so if the two wheels are too offset, it is simple to show that you must work hard and use the planetary gear reducer reducer.When maintaining the standard of a sprocket, it is also necessary to pay attention to checking and correcting the offset of a sprocket standard.

Previous: 3 points sprocket pitch

Next: Benz timing sprocket manufacturers