The sprocket manufacturer's products should be replaced in time after wear

Time: 2020-1-7 14:26:05 Source: Hebei Ever-Power Sprocket Factory

Sprocket manufacturer maintenance:

After the sprocket is severely worn, the new sprocket and the new sprocket should be replaced at the same time to ensure good meshing.It is not possible to replace only a new sprocket or a new sprocket alone.Otherwise it will cause poor meshing and accelerate the wear of new sprocket or new sprocket.When the tooth surface of the sprocket is worn to a certain degree, it should be turned over and used in time (referring to the sprocket used with adjustable surface) to extend the use time.

The new sprocket is too long or stretched after use, making it difficult to adjust. You can remove the chain link depending on the situation, but it must be an even number.The chain link should pass through the back of the sprocket, the lock piece should be inserted outside, and the opening of the lock piece should face the opposite direction of rotation.

Sprocket manufacturersThe sprocket should be filled with lubricating oil in time during work.Lubricating oil must enter the matching gap between the roller and the inner sleeve to improve working conditions and reduce wear.

The old sprocket cannot be mixed with some new sprocket. Otherwise, the sprocket manufacturer will easily produce an impact in the transmission and break the sprocket.

When the machine is stored for a long time, the sprocket of the sprocket manufacturer should be removed and cleaned with kerosene or diesel oil, and then coated with oil or butter and stored in a dry place.

The tightness of the sprocket should be appropriate. Too tight will increase power consumption and the bearings are easy to wear; too loose sprocket manufacturers will easily jump and fall off the chain.The tightness of the sprocket is: lifted or pressed down from the middle of the sprocket, the center distance between the two sprocket is about 2%-3%.

The sprocket of the sprocket manufacturer should not swing or skew when installed on the shaft.The end faces of the two sprockets in the same transmission assembly should be in the same plane. When the center distance of the sprocket is less than 0.5 meters, the deviation can be 1 mm; when the sprocket center distance of the sprocket manufacturer is more than 0.5 meters, the deviation can be 2 mm .However, the sprocket manufacturer must not rub the side of the sprocket tooth. If the two wheels offset too much, it will easily cause chain disconnection and accelerated wear.When replacing the sprocket of the sprocket manufacturer, you must pay attention to checking and adjusting the offset.

Previous: Sprocket maintenance

Next: Basic requirements for designing sprocket