Sprocket tooth side radius

Time: 2021-3-19 10:16:18 Source: Hebei Ever-Power Sprocket Factory

The tooth side radius of the sprocket is shallowly applied to the picture of the sprocket shaft of the equipment in the book industry such as chemical industry, equipment, food special, appearance special, instrument factory, etc.
Construction Design of Sprocket Tooth Side Radius Structure
. The tooth profile of the sprocket tooth side radius is smaller than that of the care chain. It is energy-saving and easy to participate in the link and the cost is injected into the link. Carefully grow to reduce the preemption and contact stress of the link during the link. However, it must be easy to understand and special.
In general, the tooth profile of the sprocket tooth side radius end face.This is also composed of three arcs aa, ab, cd and three direct bc identities, referred to as three arcs-direct tooth profile.The tooth profile is specially made with index scissors. There is no need to lighten the end face tooth profile on the sprocket tooth side radius matter map. You only need to write "the tooth profile according to the 3RGB1244-85 rule industrial" on the map, but the sprocket tooth side radius should be light. For the tooth profile of the shaft surface, please refer to the Relational Construction Design Manual for the specifications and dimensions of the position.
. Sprocket tooth side radius structure
The tooth side radius of the small diameter sprocket generally seems to cause a panic and dangerous type. The tooth side radius of the conventional diameter sprocket often causes the web type. In order to facilitate handling, installation and reduction, a hole is opened in the web plate, and the large diameter sprocket tooth side Radius can cause butt joint, fireproof ring gear and wheel core are not technical industry, not construction and other technologies.
. Sprocket side radius technology
The sprocket tooth side radius technology should maintain the gear teeth to have sufficient structure and maturity, so the sprocket tooth side radius tooth surface generally seems to be heat treated to remove the hardness.
Sprocket tooth side radius line service
, The degree of sprocket tooth side radius should be available, too tight will be more rough and consume, the bearing is easy to gear box reducer reducer; too loose sprocket tooth side radius is easy to skip and be born.The lower degree of the sprocket tooth side radius is: mentioned or pressed from the middle of the sprocket tooth side radius, almost 2%-3% of the distance between the two sprocket tooth side radii.
, The sprocket tooth side radius equipment shaft should be wired and complete.In the medical equipment of the unified sprocket axis picture, the end faces of the four sprocket tooth side radii should be in uniform tension, and the distance between the sprocket tooth side radius and the distance is below 0.5 meters. When we share, we can miss the millimeter; the sprocket tooth side radius is the distance between the distances. In the period above .5 meters, millimeters can be missed.However, it is not possible to attend to add the performance of the sprocket tooth side radius tooth combination, so the two-wheel offset is also called easy to be born and improve the gearbox reducer reducer.The side radius of the sprocket tooth side of the line is smaller than the side radius of the sprocket tooth side of the sprocket to make the inspection and finishing offset.

Previous: Renqiu Founder Sprocket Manufacturers

Next: Wuxi sprocket manufacturers