Sprocket manufacturers analyze the causes of product wear

Time: 2019-5-9 15:00:10 Source: Hebei Ever-Power Sprocket Factory

Sprocket manufacturersAnalyze the cause of product wear

1. The material of the sprocket is not good and it is easy to cause abrasion. Generally, the sprocket is made of 45# steel, and the hardness is HRC 40-45. That is, the surface hardness is increased by heat treatment.
2. The transmission ratio of the front and rear sprockets should be changed according to the road conditions you usually drive. If you are driving on flat roads in towns, the transmission ratio can be reduced, which can improve the speed and acceleration performance. Generally speaking, if you are driving a 125 When used in towns, the transmission ratio is about 2.6 (the rear sprocket except the front sprocket),
也就是15：39，或16：41也可以。 一般125的车如果在乡村泥砂路或山路用的话传动比可以改15：41或16：45 。
You can match the sprocket according to the aspects I mentioned above. The sprocket cannot be matched randomly. If it is not matched properly, it will affect the performance and comfort of the engine.

Previous: Understand the little knowledge of the product

Next: Sprocket lubrication stainless