Analysis of Hebei sprocket manufacturers: sprocket and chain equipment requirements?

Time: 2018-5-17 11:26:00 Source: Hebei Ever-Power Sprocket Factory

What are the assembly requirements for sprocket and chain during mechanical equipment installation?2. Clean and clean before assembling.1000. The center lines of the active sprocket and the passive sprocket teeth should coincide, and the deviation shall not be greater than 2/1000 of the center distance of the two sprocket. 60. When the working edge of the chain is tightened, the assembly requirements of the sprocket and the chain during the installation of mechanical equipment What?1. Clean and clean before assembling.4.5. The center lines of the driving sprocket and the passive sprocket teeth should coincide, and the deviation should not be greater than XNUMX/XNUMX of the center distance between the two sprocket. XNUMX. When the chain is tightened on the working side, the sag of the non-working side f (see below Figure) Should comply with the design regulations.When there is no regulation and the angle α between the chain and the horizontal line is less than XNUMX°, it can be adjusted by XNUMX% to XNUMX% of the center distance L between the two sprockets.

Previous: Sprocket manufacturers tell you how to maintain gear shafts

Next: Analysis on the heat treatment process of sprocket