Electrical power UNITS FOR LIFT TABLE 1
Basic Description
This power unit is built solely for your modest lift table,Consisting of large stress gear pump, AC motor, multi-functional manifold, valves, tank, and so on. This power unit has been widely made use of in the industry of logistic gadgets including minifork lift, scissors lift and ariel functioning platforms. The lower-ing movement is managed by the solenoid valve with the velocity controlled from the adjustable needle valve.
Electrical power UNITS FOR LIFT TABLE 2
Common Description
This electrical power unit is built exclusively to the medium lift table, Consisting of extremely effecient gear pump, AC motor, multifunctional manifold, valves, tank, ect. The lowering motion is actived by the solenoid valve as well as pace controlled from the adjustable needle valve. When the lift rises to a higher positoin, however the power provide is reduce, the decreasing motion is controlled from the manual override perform.
Electrical power UNITS FOR LIFT TABLE 3
Common Description
This energy unit is designed solely for the huge lift table, Consisting of very effecient gear pump, AC motor, multi-functional manifold, valves, tank, ect. The decreasing motion is actived from the solenoid valve as well as speed controlled by a pressure compensated movement management valve.
Electrical power UNITS FOR LIFT TABLE four
Standard Description
This energy unit is created solely for the huge lift table, Consisting of very effecient gear pump, AC motor, multi-functional manifold, valves, tank, ect. The decreasing motion is actived through the solenoid valve plus the speed controlled from the adjustable needle valve. When the lift rises to a large positoin, but the electrical power supply is lower, the decreasing movement is managed from the guide override function.
Particular Notes
one. This power unit is of S3 duty cycle, which may only do the job intermittently and repeatedly, i.e. 1 minute on and 9 minutes off.
two. Clean all of the hydraulic elements concerned before set up of the electrical power unit.
three. Viscosity of the oil shoud be 15~46 cst,which really should also be clean and totally free of impurities.N46 hydraulic oil is proposed.
4. Oil altering is required right after the first a hundred operation hours,afterwards once each 3000 hrs.
five. The power unit shown is built to be mounted vertically.